Nokia Car Kit CK 100 - Use the ISO cable CA-135 or CA-152

I n s t a l l a t i o n

20

• Unplug the appropriate cables from the car radio, and insert the

ISO cable plug instead. Connect the open ends of the cables to
the car radio speakers.

• Connect one of the wires labelled Mute 1, Mute 2, or Mute 3 on

the car radio to the ISO cable. Leave the other mute wires
connected as they are.

• Insert the power cable plug of the ISO cable to the respective

connector on the hands-free unit.

• Check the +12-V power pin and the ignition pin on the car radio

and the respective pins of the ISO cable. If necessary, swap the
pins on the fuses of the ISO cable. Plug the ISO cable to the two
open ISO connectors.

2. Plug the ISO cable to the respective connector on the hands-free

unit.

After you have connected the ISO cable, connect the external input
device CU-11 and the microphone MP-2 to the respective connectors on
the hands-free unit.

To charge a compatible Nokia mobile phone through the car kit, connect
one end of the supplied charging cable CA-134 to the hands-free unit
and the other end to the 2.0-mm (0.08 inch) charging connector of the
phone.

Use the car kit amplifier for calls and the car radio amplifier
for music

In this setup, the car radio is muted when you make or receive a call.

The amplifier and equaliser of your car radio are used for music played
on a connected device that supports the A2DP profile. The built-in
amplifier of the car kit is used for calls.

Music played on A2DP devices and Nokia Maps navigation prompts
played on some Nokia device models are directed to the AUX input of
the car radio. To hear the music and prompts, select AUX input on your
car radio as the audio source. If the car radio does not have an AUX

I n s t a l l a t i o n

21

input, the music and prompts played on these devices cannot be heard
through the radio.

1. To connect the ISO cable to the car radio, do as follows:

• Unplug the appropriate cables from the car radio, and insert the

ISO cable plug instead. Connect the open ends of the cables to
the car radio speakers.

• Connect one of the wires labelled Mute 1, Mute 2, or Mute 3 on

the car radio to the ISO cable. Leave the other mute wires
connected as they are.

• Insert the power cable plug of the ISO cable to the respective

connector on the hands-free unit.

• Check the +12-V power pin and the ignition pin on the car radio

and the respective pins of the ISO cable. If necessary, swap the

CA-135/CA-152